The Basic Boot Shine | Bootblacking 101


Equipment and Materials

To do this you will need the following equipment:

  • Microfiber dusting cloth
  • Toothbrush/detail brush
  • Application brush
  • Buffing brush
  • Application cloth
  • Fine Buffing cloth
  • Water
  • Boot polish

Things to check before you begin

Firstly, is it a boot that will take hard polish?

A lot of the boots, particularly many that are favorites of the leather scene, are oil based and won’t take a hard wax well.

Wescos, work boots and matt-looking motorcycle boots tend to all fit in this category, usually these types of boots will be Matt in finish and have a high friction surface to the touch.

For those boots you will need to use an oil.

The basic principal of a shine

Boot polish works by coating the leather in a layer of wax and oil that can create a smooth surface. The smoother the surface the higher the shine.

This is why shines improve with multiple applications of wax and buffing. With each application, the polish further fills in and coats over the natural grain of the leather, making it smoother and thus more reflective.

A note on polish types

The various brands and types of polish are not all made equal when it comes to nourishing the leather.

Angelus and Lincoln provide a very good high shine and also provide nourishment to the leather, which will help prolong its life.

Dedicated high shine polishes such as Kiwiw parade gloss and Saphir mirror gloss do not nourish the leather. In fact, kiwi in particular uses silicone in their recipe, which will leech moisture out of leather over time. For this reason, if using Saphir mirror gloss or kiwi parade gloss, always use a nourishing polish or cream as your first few layers.

Clean

Assuming the boots are not massively dirty and require a soaping, start with a light misting of water and wipe down with the microfiber cloth.

The microfiber will remove all dust and grit laying on the surface, so it doesn’t interfere with the polish.

Use your toothbrush to go round Any joins in the leather and around the edge of the boot sole to make sure the hard to reach crevices are clean.

Apply polish

We start by applying polish to the leather.

Take your application cloth and wrap it around your first 2 fingers.

run it round the surface of your hard shoe wax until the cloth has a decent amount of wax on.

Press the wax to the surface of the boot and in circular motions spread it out evenly.

Repeat this until the boot is evenly covered.

Dry buff

Take your buffing brush and lightly but rapidly brush it over the boot.

You should be lightly dusting off excess wax, there is no need to press hard. Just make sure to keep the speed at a rapid pace. It’s the speed, not pressure, that will help keep an even surface.

Wet buff

Take your fine buffing cloth and spray bottle of water.

Spray a fine mist of water over the boot leather, we do this is because the water helps creates a friction between the wax in the polish, helping to smooth out the surface.

Once the area you are polishing is wet, take your buffing cloth and wrap round your first 2 fingers, just as you did with your application cloth.

Make light but rapid circular motions. You will see that over time the leather will buff up to a shine.

As with each stage, it is the speed and repetition, not pressure, that yields the best results.

2nd toe buff

This is optional, but I find people in my chair appreciate a bit of extra attention to the toes. Shiny boot toes are, after all, the thing people notice.

If you are not using a high shine wax all over, this would be time to switch out and apply a higher gloss polish.

You may also wish to switch out your buffing cloth to an even finer medium. I use damp cotton balls.

Repeat all the steps as before but only on the toe.


Now you know the basics of how to shine a boot, and this will be your foundation on the rest of your bootblacking skills will stem.